DTC P1195 [G6]
id010295956700
|
DTC P1195 |
BARO sensor (in PCM) malfunction |
|---|---|
|
DETECTION CONDITION
|
• Input voltage from the BARO sensor is below 1.5 V or above 4.5 V when the ignition switch is turned on.
|
|
POSSIBLE CAUSE
|
• BARO sensor (in PCM) malfunction.
|
Diagnostic procedure
|
STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
• Make sure to reconnect all disconnected connectors.
• Clear DTC from memory using the M-MDS.
• Start engine.
• Retrieve the DTCs using the M-MDS.
• Is same DTC present?
|
Yes
|
Replace the PCM, then go to the next step.
|
|
No
|
Go to the next step.
|
||
|
2
|
VERIFY AFTER REPAIR PROCEDURE
• Perform “AFTER REPAIR PROCEDURE”.
(See AFTER REPAIR PROCEDURE [G6].)
• Is there any DTC present?
|
Yes
|
Go to applicable DTC inspection.
(See DTC TABLE [G6].)
|
|
No
|
Troubleshooting completed.
|
||