GENERATOR REMOVAL/INSTALLATION [WLT-1, WLT-2, WL-3, WL-C, WE-C]

id0117b3800200

Warning
•  When the battery cables are connected, touching the vehicle body with generator terminal B will generate sparks. This can cause personal injury, fire, and damage to the electrical components. Always disconnect the battery negative cable before performing the following operation.

1.  Disconnect the negative battery cable.

2.  Remove in the order indicated in the table.

3.  Install in the reverse order of removal.

4.  Inspect the drive belt deflection/tension. (See DRIVE BELT INSPECTION [WLT-1, WLT-2].) (See DRIVE BELT INSPECTION [WL-3].) (See DRIVE BELT INSPECTION [WL-C, WE-C].)

absggw00001459

1
B terminal cable
2
Generator connector
3
Drive belt
4
Generator
(See Generator Installation Note.)


Generator Installation Note

1.  Tighten locknut A by hand.

2.  Tighten mounting nut B.

Tightening torque:
12—25 N·m {123—254 kgf·cm, 107—221 in·lbf}

3.  Adjust the drive belt deflection or tension by turning adjusting bolt C. (See DRIVE BELT INSPECTION [WLT-1, WLT-2].) (See DRIVE BELT INSPECTION [WL-3].) (See DRIVE BELT INSPECTION [WL-C, WE-C].)

4.  Tighten mounting nut B and locknut A.