IGNITER INSPECTION [F2]

id011894103600

1. Disconnect the igniter connector.

2. Turn the ignition switch on and measure the voltage at connector terminal A using a tester.

arnffw00000693

Specification

Battery positive voltage

3. Turn the ignition switch off and verify that there is continuity between terminal B and the body ground.

4. While cranking the engine, measure the voltage at terminal C using a tester.

Specification

Approx. 0.5 V

5. If voltage and continuity are okay, replace the igniter. (See IGNITION COIL REMOVAL/INSTALLATION [F2].)