POWER STEERING PRESSURE (PSP) SWITCH INSPECTION [G6]

id014095803100

Continuity inspection

Note

• Perform the following test only when directed.

1. Disconnect the PSP switch connector.

2. Start the engine.

3. Verify that the continuity between PSP switch terminal A and body ground is as indicated in the table.

• If not as specified, replace the PSP switch.

• If there is no malfunction, but PID value is out of specification, inspect for the following:

4. Repair or replace faulty areas.

5. Reconnect the PSP switch connector.

Specification

Condition

Continuity

Steering wheel in straight ahead position

No

Steering wheel fully turned

Yes

Condition	Continuity
Steering wheel in straight ahead position	No
Steering wheel fully turned	Yes

arnffw00000859

Open Circuit

― PSP signal circuit (PSP switch connector terminal and PCM connector terminal 1P through common connector)

― GND circuit (PSP switch body and GND)

Short Circuit

― PSP signal circuit (PSP switch connector terminal and PCM connector terminal 1P through common connector to GND)

Power steering fluid

• Fluid level

• Fluid leakage

• Fluid pressure