CONTROL LEVER POSITION SENSOR INSPECTION [WLT-1, WLT-2]

id014096857300

WLT-2 Only

Output voltage inspection

Note

• Perform the following test only when directed.

1. Verify that the FIP control lever is fully closed.

2. Turn the engine switch on and measure the PCM terminal J voltage.

Specification

Measuring condition	Voltage (V)
Accelerator pedal is fully open.	Approx. 4.2
Accelerator pedal is fully closed.	Approx. 0.8—1.5

3. If not as specified, replace the control lever position sensor. When the reading is out of specification, send the FIP with the control lever position sensor to a distributor to repair. If the PCM terminal voltage is out of specification, inspect as follows and repair or replace as necessary.

Open circuit

• Constant voltage circuit (Control lever position sensor connector terminal B and PCM connector terminal A through common connector)

• Control lever position signal circuit (Control lever position sensor connector terminal A and PCM connector terminal J through common connector)

• Ground circuit (Control lever position sensor connector terminal C and PCM connector terminal B through common connector)

Short circuit

• Control lever position sensor connector terminal B and PCM connector terminal A through common connector to ground

• Control lever position sensor connector terminal A and PCM connector terminal J through common connector to ground

4. Repair or replace faulty areas.

5. Reconnect the 8-pin connector of FIP.