CLUTCH PEDAL POSITION (CPP) SWITCH INSPECTION [WL-3]

id0140b5801600

Note

• Perform the following inspection only when directed.

Continuity Inspection

1. Disconnect the CPP switch connector.

2. Inspect continuity between the CPP switch terminals using an ohmmeter.

• If not as specified, replace the CPP switch.

• If as specified, carry out the "Circuit Open/Short Inspection".

Specification

CPP switch	Clutch pedal	Continuity condition
Push the rod	Released	No continuity
Except above	Depressed	Continuity

dbg140awb328

3. Reconnect the CPP switch connector.

Circuit open/short inspection

1. Inspect for an open or short circuit in the following wiring harnesses.

• If there is an open or short circuit, repair or replace wiring harnesses.

dbg140awb329

dbg140awb305

Open circuit

• Power circuit (CPP switch connector terminal A and PCM connector terminal 1D)

• Ground circuit (CPP switch connector terminal B and ground.)

Short circuit

• CPP switch connector terminal A and PCM connector terminal 1D short to ground.