FRONT ABS WHEEL-SPEED SENSOR INSPECTION

id041300801300

Visual Inspection

1. Remove the wheel and tire, and inspect the sensor for looseness and damage. Replace the sensor if necessary.

Clearance Inspection

1. Inspect the clearance between the wheel‐speed sensor and the sensor rotor.

dbr413zwb010

Clearance

0.3—1.1 mm {0.012—0.043 in}

• If not as specified, replace the defective part(s). (ABS wheel-speed sensor, ABS sensor rotor and steering knuckle etc.)

Resistance Inspection

1. Disconnect the ABS wheel‐speed sensor connector.

2. Inspect the resistance at the ABS wheel‐speed sensor.

• If not as specified, replace the ABS wheel‐speed sensor.

Resistance

1.2—1.6 kilohm

Voltage Inspection

1. Jack up the vehicle on level ground and support it evenly on safety stands.

2. Disconnect the ABS wheel‐speed sensor connector.

3. Inspect each sensor by rotating each wheel one revolution per second.

• If not as specified, replace the ABS wheel‐speed sensor.

Voltage

0.15—1.2 V (AC)

Voltage Pattern Inspection

1. Jack up the vehicle on level ground and support it evenly on safety stands.

2. Disconnect the ABS wheel‐speed sensor connector.

3. Using an oscilloscope, inspect voltage pattern for distortion and noise by rotating each wheel.

dbr413zwb011

• If there is distortion or noise, inspect the ABS sensor rotor.