REFRIGERANT PRESSURE SWITCH REMOVAL/INSTALLATION

id074000802600

1.  Disconnect the negative battery cable.

2.  Discharge the refrigerant from the system. (See REFRIGERANT RECOVERY.) (See REFRIGERANT CHARGING.)

Caution

•  If moisture or foreign material enters the refrigeration cycle, cooling ability will be lowered and abnormal noise will occur. Always immediately plug all open fittings after removing any refrigeration cycle parts to keep moisture or foreign material out of the cycle.

3.  Remove the radiator grille.(L.H.D.)(See RADIATOR GRILLE REMOVAL/INSTALLATION.)

4.  Remove in the order indicated in the table.

absggw00001817

1	Refrigerant pressure switch connector
2	Refrigerant pressure switch

5.  Install in the reverse order of removal.

6.  Perform the refrigerant system performance test. (See REFRIGERANT SYSTEM PERFORMANCE TEST.)

Refrigerant Pressure Switch Installation Note

1.  Apply compressor oil to O-ring and connect the joint.