FOREWORD [IMMOBILIZER SYSTEM]

id0902e4345500

WE-C, WL-3, WL-C

Caution

•  When the engine does not start or stalls and the following DTCs are not indicated, go to engine symptom troubleshooting.

Note

•  If engine condition is normal but light stays on, inspect for short circuit between security light and immobilizer unit connector terminal M. Repair or replace the wiring harness if necessary.

1.  Turn the ignition switch to START position for 2 seconds, then back to ON position.

2.  Wait for 2 minutes.

3.  Verify the security light condition and read the DTC if indicated.

4.  If the DTC is indicated, go to troubleshooting referring to the DTC table.

WLT-2

Caution

•  When the engine does not start or stalls and the following DTCs are not indicated, go to engine symptom troubleshooting.

Note

•  When the immobilizer system is defective, the engine cannot be started.

•  If engine condition is normal but light stays on, inspect for short circuit between security light and immobilizer unit connector terminal M. Repair or replace the wiring harness if necessary.

•  The DDS1 is installed to the FIP with set bolts and cannot be removed. if there is a possibility that the DDS1 is faulty, be sure to ask your distributor to repair it.

1.  Turn the engine switch to ON position.

2.  Verify the security light condition and read the DTC if indicated.

3.  If the DTC is indicated, go to troubleshooting referring to the DTC table.