POWER WINDOW SYSTEM INITIAL SETTING

id091200803400

Note

•  A driver-side window will not fully close automatically under following the conditions:

―  The battery has been disconnected during vehicle maintenance or for other reasons.

―  The power window main switch connector, or driver-side power window motor connector has been disconnected.

1.  Turn the ignition (F2,G6)/engine (WE-C, WL-3, WL-C, WLT-1, WLT-2) switch to the ON position.

2.   Press the driver side power window main switch and fully open the driver-side window.

3.   Pull up the driver side power window main switch to manual-up position to fully close the driver side window, and keep holding the switch up at the position for about 2 seconds to complete initial setting.