REAR DOOR TRIM REMOVAL/INSTALLATION

id091700802600

1.  Disconnect the negative battery cable. (with power window system)

2.  Open the cap using a small flathead screwdriver and remove the screw.

3.  Remove the inner handle cover.

dpe917zw1035

4.  Remove the regulator handle. (with manual window) (See REGULATOR HANDLE REMOVAL.)

5.  Remove tabs A using a fastener remover and then remove the weatherstrip by pulling it upward.

dcg917zwb041

6.  Remove the screw.

dcg917zwb015

7.  Detach clips A from the front door using a fastener remover.

8.  Pull the rear door trim in the direction of the arrow and remove pin C and tabs B.

9.  Disconnect the power window subswitch connector. (with power window system)

10.  Remove the rear door trim.

11.  Install in the reverse order of removal.