1. Knee air bag installation
1) Install the knee airbag to the vehicle.
Tightening torque: 7.5 N・m { 0.8 kgf・m / 66 lb・in }
Note
- Tighten the bolts in the order shown in the diagram.
RHD
LHD
2. Steering cowl installation
1) Install the steering cowl to the steering shaft.
Tightening torque: 2.5 N・m { 0.25 kgf・m / 22.1 lb・in }
Legend
- Steering upper cowl
- Steering lower cowl
2) Turn the steering wheel 90° to the right and left and install the screw to the steering cowl.
Tightening torque: 2.5 N・m { 0.25 kgf・m / 22.1 lb・in }
Legend
- Screw
Legend
- Screw
3. SRS airbag setting
1. SRS reactivation
Warning
- Never use SRS parts from other vehicles or models.
- Make sure to check the part numbers and use the SRS components intended for the target vehicle.
1) Set the ignition switch to LOCK and remove the key.
Note
- For models with the passive entry and start system, turn the power mode OFF.
2) Make sure that the connectors of the SRS components (SRS airbag, SRS control unit, seat belt with pretensioner, SRS coil, etc.) are fully connected.
3) Install the SRS fuse to the fuse relay box, and connect the battery cable to the negative terminal of the battery.
4) Turn ON the ignition switch and verify that the SRS airbag warning light turns OFF after illuminating for 6 seconds.
Caution
- If the SRS airbag warning light does not operate properly, perform Diagnostic system check - SRS controls.
5) Referring to the following, perform the setting of the front door power window switch with AUTO UP/AUTO DOWN function.
Refer to "9.Body, Cab, Accessories 9T.Glass, Windows, Mirrors front door power window switch setting".