Vacuum switch removal

1. Preliminary and post procedures

1. Preliminary procedures

1) Open the engine hood.

2) Disconnect the battery cable from the battery negative terminal.

Caution

  • After turning OFF the ignition switch (power mode for models with passive entry and start system), do not disconnect the battery cable within 3 minutes.
  • If the battery cable is disconnected within 3 minutes, the vehicle electronic control system may malfunction.
  • If the battery cable is disconnected, perform the setting of the front door power window switch with AUTO UP/AUTO DOWN function after connecting the battery negative terminal.

2. Vacuum switch removal

1) Disconnect the harness connector from the vacuum switch and bracket.

2) Remove the vacuum switch and bracket from the vehicle.

Legend

  1. Bracket
  2. Vacuum switch
  3. Harness connector

3) Remove the vacuum switch from the bracket.

Legend

  1. Vacuum switch
  2. Bracket
Copyright Mazda Motor Corporation. All rights reserved.