1. Component views
Crew cab
Part name
- Front airbag sensor
- SRS control unit
- Floor side airbag sensor (Models with side airbags)
- Door side airbag sensor (Models with side airbags)
- Rear side airbag sensor (Models with side airbags)
2. Rear side airbag sensor installation
1) Install the rear side airbag sensor to the rear pillar.
Tightening torque: 8.0 N・m { 0.8 kgf・m / 71 lb・in }
2) Connect the connector to the rear side airbag sensor.
3. Rear pillar trim cover installation
1) Install the rear pillar lower trim cover to the rear pillar.
Legend
- Claw section
- Rear pillar lower trim cover
- Clip
4. Rear end upper trim cover installation
1) Install the rear end upper trim cover to the body panel.
Caution
- For models with center top tethers (bracket type), install while bending the end of the rear end upper trim to an extent that it will not get damaged.
Models with center top tethers (bracket type)
Legend
- Seat belt guide cover
- Rear end upper trim cover
- Clip
- Claw section
- Hook
- Bend the end of the rear end upper trim cover.
- Install the rear end upper trim.
- Center top tether (Bracket type)
Models without center top tethers (bracket type)
Legend
- Seat belt guide cover
- Rear end upper trim cover
- Clip
- Claw section
- Hook
5. Rear door finisher installation
1) Install the rear door finisher to the body.
6. Rear sill plate installation
1) Install the rear sill plate to the floor.
Legend
- Rear sill plate
- Clip
- Claw section
7. SRS airbag setting
1. SRS reactivation
Warning
- Never use SRS parts from other vehicles or models.
- Make sure to check the part numbers and use the SRS components intended for the target vehicle.
1) Set the ignition switch to LOCK and remove the key.
Note
- For models with the passive entry and start system, turn the power mode OFF.
2) Make sure that the connectors of the SRS components (SRS airbag, SRS control unit, seat belt with pretensioner, SRS coil, etc.) are fully connected.
3) Install the SRS fuse to the fuse relay box, and connect the battery cable to the negative terminal of the battery.
4) Turn ON the ignition switch and verify that the SRS airbag warning light turns OFF after illuminating for 6 seconds.
Caution
- If the SRS airbag warning light does not operate properly, perform Diagnostic system check - SRS controls.
5) Referring to the following, perform the setting of the front door power window switch with AUTO UP/AUTO DOWN function.
Refer to "9.Body, Cab, Accessories 9T.Glass, Windows, Mirrors front door power window switch setting".