Hazard warning flasher switch removal

1. Preliminary and post procedures

1. Preliminary procedures

1) Open the engine hood.

2) Disconnect the battery cable from the battery negative terminal.

Caution

  • After turning OFF the ignition switch (power mode for models with passive entry and start system), do not disconnect the battery cable within 3 minutes.
  • If the battery cable is disconnected within 3 minutes, the vehicle electronic control system may malfunction.
  • If the battery cable is disconnected, perform the setting of the front door power window switch with AUTO UP/AUTO DOWN function after connecting the battery negative terminal.

2. Audio and navigation system removal

1. Models equipped with display units

1) Remove the display unit as a set with the bezel from the instrument panel.

Caution

  • When removing the display unit, place a cloth to the instrument panel.
  • If a cloth is not used, the surface of the instrument panel may be damaged.

Legend

  1. Bezel
  2. Display unit
  3. Clip

2) Disconnect the connector from the display unit.

2. Models equipped with 2DIN audio

1) Remove the 2DIN audio as a set with the bezel from the instrument panel.

Caution

  • When removing the 2DIN audio, place a cloth to the instrument panel.
  • If a cloth is not used, the surface of the instrument panel may be damaged.

Legend

  1. Bezel
  2. 2DIN audio
  3. Clip

2) Disconnect the connector from the 2DIN audio.

3. Hazard warning flasher switch removal

1) Remove the hazard warning flasher switch from the instrument panel (upper side).

Legend

  1. Hazard warning flasher switch
Copyright Mazda Motor Corporation. All rights reserved.