4WD switch removal

1. Preliminary and post procedures

1. Preliminary procedures

1) Open the engine hood.

2) Disconnect the battery cable from the battery negative terminal.

Caution

  • After turning OFF the ignition switch (power mode for models with passive entry and start system), do not disconnect the battery cable within 3 minutes.
  • If the battery cable is disconnected within 3 minutes, the vehicle electronic control system may malfunction.
  • If the battery cable is disconnected, perform the setting of the front door power window switch with AUTO UP/AUTO DOWN function after connecting the battery negative terminal.

2. Glove box removal

1. Models with manual A/C

1) Remove the glove box from the instrument panel.

RHD

Legend

  1. Glove box

LHD

Legend

  1. Glove box

3. Knee air bag removal

1. Models with knee airbags

Refer to "8.Restraints 8B.Airbag Systems knee air bag removal".

4. Instrument panel driver-side lower cover removal

1. Models without knee airbags

1) Disconnect the wire from each lever.

2) Remove the hood lock control lever and fuel filler lid opener lever from the instrument panel driver-side lower cover.

Note

  • Press the claw section and pull out each lever.

RHD

Legend

  1. Hood lock control lever
  2. Fuel filler lid opener lever
  3. Claw section

LHD

Legend

  1. Fuel filler lid opener lever
  2. Hood lock control lever
  3. Claw section

3) Remove the instrument panel driver-side lower cover from the instrument panel.

RHD

Legend

  1. Instrument panel driver-side lower cover

LHD

Legend

  1. Instrument panel driver-side lower cover

4) Remove the connector from the instrument panel driver-side lower cover.

5. Audio and navigation system removal

1. Models equipped with display units

1) Remove the display unit as a set with the bezel from the instrument panel.

Caution

  • When removing the display unit, place a cloth to the instrument panel.
  • If a cloth is not used, the surface of the instrument panel may be damaged.

Legend

  1. Bezel
  2. Display unit
  3. Clip

2) Disconnect the connector from the display unit.

3) Remove the audio center unit from the instrument panel.

Legend

  1. Audio center unit

4) Disconnect the connector from the audio center unit.

2. Models equipped with 2DIN audio

1) Remove the 2DIN audio as a set with the bezel from the instrument panel.

Caution

  • When removing the 2DIN audio, place a cloth to the instrument panel.
  • If a cloth is not used, the surface of the instrument panel may be damaged.

Legend

  1. Bezel
  2. 2DIN audio
  3. Clip

2) Disconnect the connector from the 2DIN audio.

6. Instrument panel passenger-side upper cover removal

1) Remove the instrument panel passenger-side upper cover from the instrument panel.

High grade type (RHD)

Legend

  1. Instrument panel passenger-side upper cover
  2. Screw

High grade type (LHD)

Legend

  1. Instrument panel passenger-side upper cover
  2. Screw

Low grade type (RHD)

Legend

  1. Instrument panel passenger-side upper cover

Low grade type (LHD)

Legend

  1. Instrument panel passenger-side upper cover

7. Meter cluster removal

1) Remove the meter cluster from the instrument panel.

RHD

Legend

  1. Clip
  2. Claw section

LHD

Legend

  1. Clip
  2. Claw section

8. Control panel and control lever removal

1. Models with manual A/C

1) Remove the instrument panel (middle side) from the instrument panel (lower side).

RHD

Legend

  1. Instrument panel (Middle side)
  2. Clip

LHD

Legend

  1. Instrument panel (Middle side)
  2. Clip

2) Disconnect the control cable from the lock clamp section.

3) Disconnect the control cable from the intake lever.

RHD

Legend

  1. Lock clamp
  2. Intake lever
  3. Blower
  4. Control cable

LHD

Legend

  1. Control cable
  2. Intake lever
  3. Lock clamp
  4. Blower

4) Remove the control lever from the instrument panel.

5) Disconnect the connector from the control lever.

Legend

  1. Control lever

2. Models with auto A/C

1) Remove the instrument panel (middle side) from the instrument panel (lower side).

RHD

Legend

  1. Instrument panel (Middle side)
  2. Clip

LHD

Legend

  1. Instrument panel (Middle side)
  2. Clip

2) Remove the control panel from the instrument panel.

3) Disconnect the connector from the control panel.

Legend

  1. Control panel

9. Center console removal

1) Remove the center console from the instrument panel.

Models with console boxes

Legend

  1. Center console

Except models with console boxes

Legend

  1. Center console
  2. Extension

2) Disconnect the connector from the center console.

10. 4WD switch removal

1) Remove the 4WD switch from the center console.

Legend

  1. 4WD switch
  2. Center console
Copyright Mazda Motor Corporation. All rights reserved.