Front door speaker removal

1. Preliminary and post procedures

1. Preliminary procedures

1) Open the engine hood.

2) Disconnect the battery cable from the battery negative terminal.

Caution

  • After turning OFF the ignition switch (power mode for models with passive entry and start system), do not disconnect the battery cable within 3 minutes.
  • If the battery cable is disconnected within 3 minutes, the vehicle electronic control system may malfunction.
  • If the battery cable is disconnected, perform the setting of the front door power window switch with AUTO UP/AUTO DOWN function after connecting the battery negative terminal.

2. Window regulator handle removal

1. Models without power windows

1) Remove the window regulator handle from the front door.

Legend

  1. Window regulator handle
  2. Locking pin
  3. Washer

3. Front door power window switch removal

1. Models with power windows

1) Remove the armrest from the front door trim pad.

Note

  • The armrest for Australia cannot be disconnected completely from the front door trim pad.

For Australia

Legend

  1. Armrest

Except for Australia

Legend

  1. Armrest

2) Remove the front door power window switch from the front door trim pad.

For Australia

Legend

  1. Front door power window switch
  2. Clip

Except for Australia

Legend

  1. Front door power window switch
  2. Clip

3) Disconnect the connector from the front door power window switch.

4. Door mirror cover removal

1) Remove the door mirror cover from the front door.

Legend

  1. Clip
  2. Door mirror cover

5. Front door trim pad removal

1) Open the garnish and cover with a small flathead screwdriver, etc., and remove the screws.

2) Pull out the clips of the front door trim pad.

3) Remove the front door trim pad from the front door.

Models with power windows

Legend

  1. Clip position
  2. Cover
  3. Garnish
  4. Screw

Models without power windows

Legend

  1. Clip position
  2. Cover
  3. Screw

4) Disconnect the door lock cable from the inside lever.

6. Door speaker removal

1) Disconnect the connector from the front door speaker.

Legend

  1. Screw
  2. Front door speaker
  3. Connector
  4. Harness clip

2) Remove the front door speaker from the front door.

Legend

  1. Front door speaker
  2. Screw
Copyright Mazda Motor Corporation. All rights reserved.