1. Component views
Rear door
Part name
- Door harness
- Rear door glass
- Weather strip
- Rear door panel
- Glass-run
- Outer waist seal
- Rear door garnish
- Insulator upper cover
- Upper glass-run rear channel
- Bolt
- Lower glass-run rear channel
- Bolt
- Torx screw
- Rear door lock
- Outside handle
- Torx screw
- Waterproof sheet
- Rear door window regulator
- Bolt
- Inside lever
- Check arm
- Nut
- Speaker
- Rear door trim pad
- Armrest
- Cover
- Screw
- Garnish
- Power window switch
Tightening torque
10: 7.0 N・m { 0.7 kgf・m / 62 lb・in }
12: 7.0 N・m { 0.7 kgf・m / 62 lb・in }
13: 7.0 N・m { 0.7 kgf・m / 62 lb・in }
16: 6.0 N・m { 0.6 kgf・m / 53 lb・in }
19: 9.0 N・m { 0.9 kgf・m / 80 lb・in }
22: 7.0 N・m { 0.7 kgf・m / 62 lb・in }
27: 2.0 N・m { 0.2 kgf・m / 18 lb・in }
2. Rear door power window switch removal
1) Remove the armrest from the rear door trim pad.
Legend
- Armrest
2) Remove the rear door power window switch from the rear door trim pad.
3) Disconnect the connector from the rear door power window switch.
Legend
- Rear door power window switch
- Claw section
3. Rear door trim pad removal
1) Remove the rear door upper cover from the rear door.
2) Open the garnish and cover with a small flathead screwdriver, etc., and remove the screws.
3) Pull out the clips of the rear door trim panel.
Legend
- Rear door upper cover
- Clip position
- Screw
- Cover
- Garnish
4) Remove the rear door trim pad from the rear door.
Caution
- When removing, be careful not to let the door lock cover open because the door lock cable is connected to the inside lever.
Legend
- Door lock (When the cover is closed)
- Door lock cable
- Door lock (When the cover is opened)
5) Disconnect the door lock cable from the inside lever.
4. Insulator upper cover removal
1) Remove the insulator upper cover from the rear door.
Legend
- Insulator upper cover
5. Inside lever removal
1) Remove the inside lever from the rear door trim pad.
6. Outer waist seal removal
1) Remove the outer waist seal from the rear door.
7. Bracket removal
1) Remove the bracket from the rear door.
8. Rear door speaker removal
1) Disconnect the connector from the rear door speaker.
Legend
- Screw
- Rear door speaker
- Connector
- Harness clip
2) Remove the rear door speaker from the rear door.
Legend
- Rear door speaker
- Screw
9. Waterproof sheet removal
1) Remove the water proof sheet from the rear door.
10. Glass-run rear channel removal
1) Remove the lower glass-run rear channel from the rear door.
Legend
- Lower glass-run rear channel
2) Remove the upper glass-run rear channel from the rear door.
Legend
- Upper glass-run rear channel
11. Rear door glass removal
1) Remove the rear door glass from the rear door.
Caution
- Do not reuse the bolt.
12. Glass-run removal
1) Remove the glass-run rear from the rear door.
13. Rear door window regulator removal
1) Remove the rear door window regulator from the rear door.
Caution
- Do not reuse the bolt.
Legend
- Bolt
- Rear door window regulator
2) Disconnect the connector from the power window motor.
14. Rear door lock removal
1) Disconnect the connector from the door lock.
2) Disconnect the rod from the outside handle bracket.
3) Remove the door lock from the rear door.
Legend
- Door lock
15. Outside handle removal
1) Remove the cover from the rear door.
2) Loosen the handle cap screw.
Legend
- Cover
- Screw
3) Remove the handle cap from the rear door.
4) Remove the outside handle from the rear door.
Legend
- Outside handle bracket
- Sheet
- Handle cap
- Outside handle
5) Remove the sheet from the rear door.
6) Remove the outside handle bracket from the rear door.
16. Rear door check arm removal
1) Remove the rear door check arm from rear door.
17. Weather strip removal
1) Remove the weather strip from the rear door.
18. Door harness removal
1) Remove the door harness from the rear door.