1. Boost pressure sensor installation
1) Install the boost pressure sensor to the inlet manifold.
Tightening torque: 5.0 N・m { 0.5 kgf・m / 44 lb・in }
2) Connect the connector to the boost pressure sensor.
2. Preliminary and post procedures
1. Post procedures
1) Connect the battery cable to the battery negative terminal.
2) Referring to the following, perform the setting of the front door power window switch with AUTO UP/AUTO DOWN function.
Refer to "9.Body, Cab, Accessories 9T.Glass, Windows, Mirrors front door power window switch setting".
3) Close the engine hood.
3. Boost pressure sensor adjustment
1. Barometric pressure 0-point learning
1) Connect the scan tool to the DLC.
2) Turn ON the ignition switch.
3) Select the scan tool item.
- Diagnostics > Engine > 4JJ3 > Special Function > Baro Press Zero Learning Data Reset
4) Perform the barometric pressure 0-point learning by following the on-screen instructions.
5) After completing the barometric pressure 0-point learning, turn OFF the ignition switch for 30 seconds.