front hub reassembly

1. Component views

Front hub and disc rotor (2WD (Except high ride suspension specifications))

Part name

Tightening torque

1: 93 to 113 N・m { 9.5 to 11.5 kgf・m / 69 to 83 lb・ft }

7: 85 N・m { 8.7 kgf・m / 63 lb・ft }

Front hub and disc rotor (2WD (High ride suspension specifications))

Part name

Tightening torque

5: 85 N・m { 8.7 kgf・m / 63 lb・ft }

Front hub and disc rotor (4WD)

Part name

Tightening torque

4: 127 N・m { 13.0 kgf・m / 94 lb・ft }

8: 85 N・m { 8.7 kgf・m / 63 lb・ft }

1) Place the front hub on a wooden working table or approx. 15 x 15 mm {6 x 6 in} wooden block.

To protect the wheel pin end and threads

2) Install the wheel pin to the front hub using a hammer.

3) Secure the brake rotor using a vise and protective pad.

4) Install the front hub to the brake rotor.

Tightening torque: 93 to 113 N・m { 9.5 to 11.5 kgf・m / 69 to 83 lb・ft }

Note

When reusing the front hub and brake rotor, install them according to the alignment marks that were made before disassembling.

Note

When replacing the front hub or brake rotor with a new one, install it according to the markings as shown in the diagram.
Install so that the markings are as close to each other as possible.

Legend

1) Place the front hub on a wooden working table or approx. 15 x 15 mm {6 x 6 in} wooden block.

To protect the wheel pin end and threads

2) Install the wheel pin to the front hub using a hammer.

3) Install the front hub to the brake rotor.

Legend

1) Place the front hub on a wooden working table or approx. 15 x 15 mm {6 x 6 in} wooden block.

To protect the wheel pin end and threads

2) Install the front hub to the brake rotor.

Legend