EGR gas pressure sensor removal (4JJ3 with DPD)

1. Preliminary and post procedures

1. Preliminary procedures

1) Open the engine hood.

2) Disconnect the battery cable from the battery negative terminal.

Caution

  • After turning OFF the ignition switch (power mode for models with passive entry and start system), do not disconnect the battery cable within 3 minutes.
  • If the battery cable is disconnected within 3 minutes, the vehicle electronic control system may malfunction.
  • If the battery cable is disconnected, perform the setting of the front door power window switch with AUTO UP/AUTO DOWN function after connecting the battery negative terminal.

2. Engine cover removal

1) Remove the engine cover from the engine.

Legend

  1. Engine cover

3. EGR gas pressure sensor removal

1) Disconnect the connector from the EGR gas pressure sensor.

2) Remove the EGR gas pressure sensor from the adapter.

Legend

  1. EGR gas pressure sensor
Copyright Mazda Motor Corporation. All rights reserved.