1. Preliminary and post procedures
1. Preliminary procedures
1) Open the engine hood.
2) Disconnect the battery cable from the battery negative terminal.
Caution
- After turning OFF the ignition switch (power mode for models with passive entry and start system), do not disconnect the battery cable within 3 minutes.
- If the battery cable is disconnected within 3 minutes, the vehicle electronic control system may malfunction.
- If the battery cable is disconnected, perform the setting of the front door power window switch with AUTO UP/AUTO DOWN function after connecting the battery negative terminal.
2. Air intake hose removal
1) Remove the air intake hose from the intake air duct and intercooler.
Legend
- Intercooler
- Air intake hose
- Intake air duct
- Clamp
3. Intake air duct removal
1) Disconnect the connector from the boost pressure and CAC temperature sensor.
2) Remove the intake air duct from the intake throttle valve.
4. Relief valve control solenoid valve removal
1) Disconnect the vacuum hose from the relief valve control solenoid valve.
2) Disconnect the connector from the relief valve control solenoid valve.
3) Remove the relief valve control solenoid valve and bracket from the relief valve.
4) Remove the relief valve control solenoid valve from the bracket.
Legend
- Relief valve control solenoid valve
- Bracket