Swirl control solenoid valve installation (4JJ3 with DPD)

1) Install swirl control solenoid valve to the bracket.

2) Install the swirl control solenoid valve and bracket as a set to the inlet manifold.

Tightening torque: 25 N・m { 2.5 kgf・m / 18 lb・ft }

3) Connect the vacuum hose to swirl control solenoid valve.

4) Connect the connector to swirl control solenoid valve.

1) Install the intake duct to the intake throttle valve.

Tightening torque: 10.0 N・m { 1.0 kgf・m / 89 lb・in } Bolt

Tightening torque: 4.0 N・m { 0.4 kgf・m / 35 lb・in } Clamp (Intake throttle valve side)

2) Connect the air intake hose to the intercooler.

Tightening torque: 5.0 N・m { 0.5 kgf・m / 44 lb・in } Clamp (Intercooler side)

3) Connect the connector to charge air cooler temperature sensor 2.

1) Install the engine cover to the engine.

Legend

1. Post procedures

1) Connect the battery cable to the battery negative terminal.

2) Referring to the following, perform the setting of the front door power window switch with AUTO UP/AUTO DOWN function.

Refer to "9.Body, Cab, Accessories 9T.Glass, Windows, Mirrors front door power window switch setting".

3) Close the engine hood.