Rear door power window switch removal

1. Preliminary and post procedures

1. Preliminary procedures

1) Open the engine hood.

2) Disconnect the battery cable from the battery negative terminal.

Caution

  • After turning OFF the ignition switch (power mode for models with passive entry and start system), do not disconnect the battery cable within 3 minutes.
  • If the battery cable is disconnected within 3 minutes, the vehicle electronic control system may malfunction.
  • If the battery cable is disconnected, perform the setting of the front door power window switch with AUTO UP/AUTO DOWN function after connecting the battery negative terminal.

2. Rear door power window switch removal

1) Remove the armrest from the rear door trim pad.

Legend

  1. Armrest

2) Remove the rear door power window switch from the rear door trim pad.

3) Disconnect the connector from the rear door power window switch.

Legend

  1. Rear door power window switch
  2. Claw section
Copyright Mazda Motor Corporation. All rights reserved.