Washer tank removal

1. Component views

Washer

Part name

  1. Washer tank
  2. Bolt
  3. Tank joint
  4. Washer motor

Tightening torque

2: 5.9 N・m { 0.6 kgf・m / 52 lb・in }

2. Preliminary and post procedures

1. Preliminary procedures

1) Open the engine hood.

2) Disconnect the battery cable from the battery negative terminal.

Caution

  • After turning OFF the ignition switch (power mode for models with passive entry and start system), do not disconnect the battery cable within 3 minutes.
  • If the battery cable is disconnected within 3 minutes, the vehicle electronic control system may malfunction.
  • If the battery cable is disconnected, perform the setting of the front door power window switch with AUTO UP/AUTO DOWN function after connecting the battery negative terminal.

3. Inner liner removal

1) Remove the inner liner from the front fender panel.

4. Washer tank removal

1) Remove the tank joint from the washer tank.

Legend

  1. Tank joint
  2. Bolt

2) Disconnect the connector from the washer motor.

Legend

  1. Washer motor
  2. Washer tank
  3. Washer motor harness

3) Remove the washer tank from vehicle.

Copyright Mazda Motor Corporation. All rights reserved.