Door side airbag sensor removal

1. Component views

Regular cab

Part name

  1. Front airbag sensor
  2. SRS control unit
  3. Floor side airbag sensor (Models with side airbags)
  4. Door side airbag sensor (Models with side airbags)

Crew cab

Part name

  1. Front airbag sensor
  2. SRS control unit
  3. Floor side airbag sensor (Models with side airbags)
  4. Door side airbag sensor (Models with side airbags)
  5. Rear side airbag sensor (Models with side airbags)

Extend cab

Part name

  1. Front airbag sensor
  2. SRS control unit
  3. Floor side airbag sensor (Models with side airbags)
  4. Door side airbag sensor (Models with side airbags)
  5. Rear side airbag sensor (Models with side airbags)

2. SRS airbag preparation

1. SRS deactivation

1) Set the ignition switch to LOCK and remove the key.

Note

  • For models with the passive entry and start system, turn the power mode OFF.

2) Remove the SRS fuse from the fuse relay box.

3) Disconnect the battery cable from the battery negative terminal.

Caution

  • After turning OFF the ignition switch (power mode for models with passive entry and start system), do not disconnect the battery cable within 3 minutes.
  • If the battery cable is disconnected within 3 minutes, the vehicle electronic control system may malfunction.
  • If the battery cable is disconnected, perform the setting of the front door power window switch with AUTO UP/AUTO DOWN function after connecting the battery negative terminal.
  • After disconnecting the battery cable, do not perform work for approximately 15 seconds.

3. Front door power window switch removal

1) Remove the armrest from the front door trim pad.

Note

  • The armrest for Australia cannot be disconnected completely from the front door trim pad.

For Australia

Legend

  1. Armrest

Except for Australia

Legend

  1. Armrest

2) Remove the front door power window switch from the front door trim pad.

For Australia

Legend

  1. Front door power window switch
  2. Clip

Except for Australia

Legend

  1. Front door power window switch
  2. Clip

3) Disconnect the connector from the front door power window switch.

4. Door mirror cover removal

1) Remove the door mirror cover from the front door.

Legend

  1. Clip
  2. Door mirror cover

5. Front door trim pad removal

1) Open the garnish and cover with a small flathead screwdriver, etc., and remove the screws.

2) Pull out the clips of the front door trim pad.

3) Remove the front door trim pad from the front door.

Models with power windows

Legend

  1. Clip position
  2. Cover
  3. Garnish
  4. Screw

4) Disconnect the door lock cable from the inside lever.

6. Door side airbag sensor removal

1) Disconnect the connector from the door side airbag sensor.

2) Remove the door side airbag sensor from the front door.

Legend

  1. Door side airbag sensor
Copyright Mazda Motor Corporation. All rights reserved.