CMP sensor removal (4JJ3 without DPD)

1. Preliminary and post procedures

1. Preliminary procedures

1) Open the engine hood.

2) Disconnect the battery cable from the battery negative terminal.

Caution

  • After turning OFF the ignition switch (power mode for models with passive entry and start system), do not disconnect the battery cable within 3 minutes.
  • If the battery cable is disconnected within 3 minutes, the vehicle electronic control system may malfunction.
  • If the battery cable is disconnected, perform the setting of the front door power window switch with AUTO UP/AUTO DOWN function after connecting the battery negative terminal.

2. Engine cover removal

1) Remove the engine cover from the engine.

Legend

  1. Engine cover

3. CMP sensor removal

1) Disconnect the connector from the CMP sensor.

Legend

  1. CMP sensor connector

2) Remove the CMP sensor from the timing chain upper cover.

Caution

  • Do not reuse the O-ring.

Legend

  1. O-ring
  2. CMP sensor
Copyright Mazda Motor Corporation. All rights reserved.