Stoplight switch removal

1. Component views

Brake pedal

Part name

  1. pedal stopper
  2. Bolt
  3. Push rod pin
  4. Stoplight switch
  5. Brake pedal
  6. pedal pad
  7. Snap pin
  8. Nut

Tightening torque

2: 27 to 39 N・m { 2.8 to 4.0 kgf・m / 20 to 29 lb・ft }

8: 18 to 24 N・m { 1.8 to 2.4 kgf・m / 13 to 18 lb・ft }

2. Preliminary and post procedures

1. Preliminary procedures

1) Open the engine hood.

2) Disconnect the battery cable from the battery negative terminal.

Caution

  • After turning OFF the ignition switch (power mode for models with passive entry and start system), do not disconnect the battery cable within 3 minutes.
  • If the battery cable is disconnected within 3 minutes, the vehicle electronic control system may malfunction.
  • If the battery cable is disconnected, perform the setting of the front door power window switch with AUTO UP/AUTO DOWN function after connecting the battery negative terminal.

3. Stoplight switch removal

1) Remove the stoplight switch from the brake pedal.

Legend

  1. Stoplight switch
  2. pedal stopper
  3. Snap pin
  4. Brake pedal
  5. pedal pad
  6. Push rod pin
Copyright Mazda Motor Corporation. All rights reserved.