Fuel filter element removal (4JJ3 without DPD)

1. Preliminary and post procedures

1. Preliminary procedures

1) Open the engine hood.

2) Disconnect the battery cable from the battery negative terminal.

Caution

  • After turning OFF the ignition switch (power mode for models with passive entry and start system), do not disconnect the battery cable within 3 minutes.
  • If the battery cable is disconnected within 3 minutes, the vehicle electronic control system may malfunction.
  • If the battery cable is disconnected, perform the setting of the front door power window switch with AUTO UP/AUTO DOWN function after connecting the battery negative terminal.

2. Fuel filter element removal

1) Remove the element case and O-ring from the fuel filter body.

2) Remove the fuel filter element from the element case.

Caution

  • Do not reuse the O-ring or gasket.
  • Use an ISUZU genuine fuel filter for element replacement.

Legend

  1. Fuel filter body
  2. Fuel filter element
  3. O-ring
  4. Element case
Copyright Mazda Motor Corporation. All rights reserved.