1. Component views
Extend cab
Part name
- Front airbag sensor
- SRS control unit
- Floor side airbag sensor (Models with side airbags)
- Door side airbag sensor (Models with side airbags)
- Rear side airbag sensor (Models with side airbags)
2. SRS airbag preparation
1. SRS deactivation
1) Set the ignition switch to LOCK and remove the key.
Note
- For models with the passive entry and start system, turn the power mode OFF.
2) Remove the SRS fuse from the fuse relay box.
3) Disconnect the battery cable from the battery negative terminal.
Caution
- After turning OFF the ignition switch (power mode for models with passive entry and start system), do not disconnect the battery cable within 3 minutes.
- If the battery cable is disconnected within 3 minutes, the vehicle electronic control system may malfunction.
- If the battery cable is disconnected, perform the setting of the front door power window switch with AUTO UP/AUTO DOWN function after connecting the battery negative terminal.
- After disconnecting the battery cable, do not perform work for approximately 15 seconds.
3. Front sill plate removal
1) Remove the front sill plate from the floor.
Extend cab
Legend
- Front sill plate
- Clip
- Claw section
4. Front door finisher removal
1) Remove the front door finisher from the body.
5. Rear end trim cover removal
1) Remove the rear end trim cover from the body panel.
Extend cab
Legend
- Rear end trim cover
- Clip
- Hook
- Claw section
6. Rear pillar trim cover removal
1) Remove the seat belt lower anchor bolt from the floor panel.
Legend
- Seat belt lower anchor bolt
2) Remove the rear pillar lower trim cover from the rear pillar.
Legend
- Claw section
- Rear pillar lower trim cover
- Clip
7. Rear side airbag sensor removal
1) Disconnect the connector from the rear side airbag sensor.
2) Remove the rear side airbag sensor from the rear pillar.
