Charge air cooler temperature sensor removal (4JJ3 with DPD)

1. Preliminary and post procedures

1. Preliminary procedures

1) Open the engine hood.

2) Disconnect the battery cable from the battery negative terminal.

Caution

  • After turning OFF the ignition switch (power mode for models with passive entry and start system), do not disconnect the battery cable within 3 minutes.
  • If the battery cable is disconnected within 3 minutes, the vehicle electronic control system may malfunction.
  • If the battery cable is disconnected, perform the setting of the front door power window switch with AUTO UP/AUTO DOWN function after connecting the battery negative terminal.

2. Engine cover removal

1) Remove the engine cover from the engine.

Legend

  1. Engine cover

3. Charge air cooler temperature sensor removal

1) Disconnect the connector from charge air cooler temperature sensor 2.

2) Remove charge air cooler temperature sensor 2 from the intake air duct.

Legend

  1. Charge air cooler temperature sensor 2
Copyright Mazda Motor Corporation. All rights reserved.