Crankshaft reassembly (4JJ3 without DPD)

1. Crankshaft reassembly

1) Apply LOCTITE 262 or equivalent to the threaded portion of the bolt.

Note

  • Perform this if reusing it.

2) Install the crank angle sensor rotor to the crankshaft.

Note

  • Install by aligning the rotor hole and pin.

Tightening torque: 12 N・m { 1.2 kgf・m / 106 lb・in }

Caution

  • The crank angle sensor rotor should not be subjected to any impacts by being dropped, etc.
  • Do not reuse the crank angle sensor rotor that is subjected to impact.

Legend

  1. Crank angle sensor rotor
  2. Bolt
  3. Rotor hole
  4. Pin section
Copyright Mazda Motor Corporation. All rights reserved.