Parking brake switch removal

1. Preliminary and post procedures

1. Preliminary procedures

1) Open the engine hood.

2) Disconnect the battery cable from the battery negative terminal.

Caution

  • After turning OFF the ignition switch (power mode for models with passive entry and start system), do not disconnect the battery cable within 3 minutes.
  • If the battery cable is disconnected within 3 minutes, the vehicle electronic control system may malfunction.
  • If the battery cable is disconnected, perform the setting of the front door power window switch with AUTO UP/AUTO DOWN function after connecting the battery negative terminal.

2. Console box removal

1. Models with console boxes

Refer to "9.Body, Cab, Accessories 9L.Exterior, Interior Trim console box removal".

3. Parking brake switch removal

1) Loosen the adjust nut using a wrench.

2) Remove the screw from the parking brake lever assembly.

3) Remove the parking brake switch from the parking brake lever.

Base grade console specifications (RHD models (LHD models are opposite))

Legend

  1. Parking brake lever
  2. Bolt
  3. Equalizer
  4. T-end
  5. Parking brake cable
  6. Adjust nut
  7. Parking brake switch
  8. Screw

Except base grade console specifications (RHD models (LHD models are opposite))

Legend

  1. Parking brake lever
  2. Bolt
  3. Equalizer
  4. T-end
  5. Parking brake cable
  6. Adjust nut
  7. Parking brake switch
  8. Screw
Copyright Mazda Motor Corporation. All rights reserved.