Rain and light sensor removal

1. Preliminary and post procedures

1. Preliminary procedures

1) Open the engine hood.

2) Disconnect the battery cable from the battery negative terminal.

Caution

  • After turning OFF the ignition switch (power mode for models with passive entry and start system), do not disconnect the battery cable within 3 minutes.
  • If the battery cable is disconnected within 3 minutes, the vehicle electronic control system may malfunction.
  • If the battery cable is disconnected, perform the setting of the front door power window switch with AUTO UP/AUTO DOWN function after connecting the battery negative terminal.

2. Rain and light sensor removal

1. Models with stereo cameras

Caution

  • Do not subject the stereo camera to a strong impact.

1) Disengage the claw section and remove the stereo camera cover lid from the stereo camera cover.

Legend

  1. Claw section
  2. Stereo camera cover lid

2) Disengage the claw section and slide the stereo camera cover in the direction of the arrow.

Legend

  1. Claw section
  2. Stereo camera cover

3) Remove the stereo camera cover from the front windshield glass.

Legend

  1. Stereo camera cover

4) Disconnect the connector from the rain and light sensor.

5) Remove the rain and light sensor from the front windshield glass.

Caution

  • Do not reuse the rain and light sensor

Legend

  1. Claw section
  2. Rain and light sensor

2. Models without stereo cameras

1) Remove the cover from the front windshield glass.

Legend

  1. Cover

2) Disconnect the connector from the rain and light sensor.

3) Remove the rain and light sensor from the front windshield glass.

Caution

  • Do not reuse the rain and light sensor

Legend

  1. Claw section
  2. Rain and light sensor
Copyright Mazda Motor Corporation. All rights reserved.