1. Preliminary and post procedures
1. Preliminary procedures
1) Open the engine hood.
2) Disconnect the battery cable from the battery negative terminal.
Caution
- After turning OFF the ignition switch (power mode for models with passive entry and start system), do not disconnect the battery cable within 3 minutes.
- If the battery cable is disconnected within 3 minutes, the vehicle electronic control system may malfunction.
- If the battery cable is disconnected, perform the setting of the front door power window switch with AUTO UP/AUTO DOWN function after connecting the battery negative terminal.
2. Front buckle side seat belt removal
1. Bucket seat
1) Disconnect the connector from the front buckle side seat belt.
2) Disconnect the seat belt switch harness from the seat.
3) Remove the front buckle side seat belt from the seat.
Right side
Legend
- Front buckle side seat belt
Left side
Legend
- Front buckle side seat belt
2. Bench seat
1) Disconnect the connector from the front buckle side seat belt.
2) Remove the front buckle side seat belt from the floor panel.
Legend
- Front buckle side seat belt