1. Component views
Front tongue side seat belt (Extend cab)
Part name
- Adjuster
- Bolt
- Door trim pad
- Seat belt upper anchor bolt
- Front tongue side seat belt
- Adjuster cover
- Bolt
- Seat belt lower anchor cover
- Seat belt lower anchor bolt
Tightening torque
2: 46 N・m { 4.7 kgf・m / 34 lb・ft }
4: 46 N・m { 4.7 kgf・m / 34 lb・ft }
7: 8.2 N・m { 0.8 kgf・m / 73 lb・in }
9: 46 N・m { 4.7 kgf・m / 34 lb・ft }
2. Front tongue side seat belt installation
1) Connect the connector to the pretensioner.
2) Install the front tongue side seat belt to the side access panel.
Tightening torque: 8.2 N・m { 0.8 kgf・m / 73 lb・in } Upper side bolt
Tightening torque: 46 N・m { 4.7 kgf・m / 34 lb・ft } Lower side bolt
Legend
- Bolt
- Front tongue side seat belt
3. Door trim pad installation
1) Install the door trim pad to the side access panel.
Legend
- Clip position
2) Install the seat belt upper anchor bolt to the side access panel.
Tightening torque: 46 N・m { 4.7 kgf・m / 34 lb・ft }
Legend
- Adjuster cover
- Seat belt upper anchor bolt
- Door trim cover
3) Install the seat belt lower anchor bolt to the side access panel.
Tightening torque: 46 N・m { 4.7 kgf・m / 34 lb・ft }
Legend
- Seat belt lower anchor cover
- Seat belt lower anchor bolt
4. Door pull case installation
1) Install the door pull case to the side access panel.
Legend
- Cover
- Screw
- Door pull case
5. SRS airbag setting
1. SRS reactivation
Warning
- Never use SRS parts from other vehicles or models.
- Make sure to check the part numbers and use the SRS components intended for the target vehicle.
1) Set the ignition switch to LOCK and remove the key.
Note
- For models with the passive entry and start system, turn the power mode OFF.
2) Make sure that the connectors of the SRS components (SRS airbag, SRS control unit, seat belt with pretensioner, SRS coil, etc.) are fully connected.
3) Install the SRS fuse to the fuse relay box, and connect the battery cable to the negative terminal of the battery.
4) Turn ON the ignition switch and verify that the SRS airbag warning light turns OFF after illuminating for 6 seconds.
Caution
- If the SRS airbag warning light does not operate properly, perform Diagnostic system check - SRS controls.
5) Referring to the following, perform the setting of the front door power window switch with AUTO UP/AUTO DOWN function.
Refer to "9.Body, Cab, Accessories 9T.Glass, Windows, Mirrors front door power window switch setting".