1. Component views
Front tongue side seat belt (Regular cab)
Part name
- Front door finisher
- Adjuster
- Bolt
- Rear pillar upper trim cover
- Rear pillar lower trim cover
- Rear end upper trim cover
- Seat belt upper anchor bolt
- Adjuster cover
- Bolt
- Seat belt lower anchor bolt
- Front tongue side seat belt
- Front sill plate
Tightening torque
3: 46 N・m { 4.7 kgf・m / 34 lb・ft }
7: 46 N・m { 4.7 kgf・m / 34 lb・ft }
9: 8.2 N・m { 0.8 kgf・m / 73 lb・in }
10: 46 N・m { 4.7 kgf・m / 34 lb・ft }
2. Front tongue side seat belt installation
1) Connect the connector to the pretensioner.
2) Install the front tongue side seat belt to the rear pillar.
Tightening torque: 8.2 N・m { 0.8 kgf・m / 73 lb・in } Upper side bolt
Tightening torque: 46 N・m { 4.7 kgf・m / 34 lb・ft } Lower side bolt
3) Install the belt guide to the rear pillar.
Legend
- Bolt
- Front tongue side seat belt
- Belt guide
4) Install the seat belt upper anchor bolt to the seat belt adjuster.
Tightening torque: 46 N・m { 4.7 kgf・m / 34 lb・ft }
5) Install the adjuster cover to the seat belt adjuster.
Legend
- Seat belt upper anchor bolt
- Adjuster cover
3. Rear pillar trim cover installation
1) Install the rear pillar lower trim cover to the rear pillar.
Legend
- Claw section
- Rear pillar lower trim cover
- Clip
2) Install the seat belt lower anchor bolt to the rear pillar.
Tightening torque: 46 N・m { 4.7 kgf・m / 34 lb・ft }
Legend
- Seat belt lower anchor bolt
4. Rear end upper trim cover installation
1) Install the rear end upper trim cover to the body panel.
Legend
- Claw section
- Rear end upper trim cover
- Clip
- Hook
5. Front door finisher installation
1) Install the front door finisher to the body.
6. Front sill plate installation
1) Install the front sill plate to the floor.
Regular cab, crew cab
Legend
- Front sill plate
- Clip
- Claw section
7. SRS airbag setting
1. SRS reactivation
Warning
- Never use SRS parts from other vehicles or models.
- Make sure to check the part numbers and use the SRS components intended for the target vehicle.
1) Set the ignition switch to LOCK and remove the key.
Note
- For models with the passive entry and start system, turn the power mode OFF.
2) Make sure that the connectors of the SRS components (SRS airbag, SRS control unit, seat belt with pretensioner, SRS coil, etc.) are fully connected.
3) Install the SRS fuse to the fuse relay box, and connect the battery cable to the negative terminal of the battery.
4) Turn ON the ignition switch and verify that the SRS airbag warning light turns OFF after illuminating for 6 seconds.
Caution
- If the SRS airbag warning light does not operate properly, perform Diagnostic system check - SRS controls.
5) Referring to the following, perform the setting of the front door power window switch with AUTO UP/AUTO DOWN function.
Refer to "9.Body, Cab, Accessories 9T.Glass, Windows, Mirrors front door power window switch setting".