Exhaust gas temperature sensor 1 (Front of DPD filter) removal (4JJ3 with DPD)

1. Preliminary and post procedures

1. Preliminary procedures

1) Open the engine hood.

2) Disconnect the battery cable from the battery negative terminal.

Caution

  • After turning OFF the ignition switch (power mode for models with passive entry and start system), do not disconnect the battery cable within 3 minutes.
  • If the battery cable is disconnected within 3 minutes, the vehicle electronic control system may malfunction.
  • If the battery cable is disconnected, perform the setting of the front door power window switch with AUTO UP/AUTO DOWN function after connecting the battery negative terminal.

2. Exhaust gas temperature sensor 1 (Front of DPD filter) removal

1) Disconnect the connector from Exhaust gas temperature sensor 1 (front of DPD filter).

2) Remove Exhaust gas temperature sensor 1 (front of DPD filter) harness from the harness bracket.

3) Remove Exhaust gas temperature sensor 1 (front of DPD filter) from the DPD.

Legend

  1. Exhaust gas temperature sensor 1 (Front of DPD filter)
Copyright Mazda Motor Corporation. All rights reserved.