Backup light bulb removal

1. Preliminary and post procedures

1. Preliminary procedures

1) Open the engine hood.

2) Disconnect the battery cable from the battery negative terminal.

Caution

  • After turning OFF the ignition switch (power mode for models with passive entry and start system), do not disconnect the battery cable within 3 minutes.
  • If the battery cable is disconnected within 3 minutes, the vehicle electronic control system may malfunction.
  • If the battery cable is disconnected, perform the setting of the front door power window switch with AUTO UP/AUTO DOWN function after connecting the battery negative terminal.

2. Rear combination light removal

1. Except horizontal type

1) Remove the rear combination light from the vehicle.

Legend

  1. Rear combination light
  2. Screw

2. Horizontal type

1) Remove the lens from the rear combination light.

Legend

  1. Tail stoplight bulb
  2. Turn signal light bulb
  3. Backup light bulb
  4. Lens

3. Backup light bulb removal

1) Remove the backup light bulb from the socket.

Except horizontal type

Legend

  1. Tail stoplight
  2. Rear turn signal light
  3. Backup light

Horizontal type

Legend

  1. Tail stoplight bulb
  2. Turn signal light bulb
  3. Backup light bulb
  4. Lens
Copyright Mazda Motor Corporation. All rights reserved.