Rear case inspection (MVL)

1) Inspect the reverse idle gear, and if excessive wear or damage is found, replace parts as necessary.

2) Measure the inner diameter of the reverse idle gear using an inside dial gauge.

Reverse idle gear

Standard value	30.007 to 30.020 mm { 1.1814 to 1.1819 in }
Limit	30.02 mm { 1.1819 in }

1) Inspect the reverse idle gear shaft, and if excessive wear or damage is found, replace parts as necessary.

2) Measure the outer diameter of the reverse idle gear shaft using a micrometer.

Reverse idle gear shaft

Standard value	24.987 to 25.000 mm { 0.9837 to 0.9843 in }
Limit	24.987 mm { 0.9837 in }