Driver airbag installation

1. Driver airbag installation

1) Connect the airbag connector to the driver airbag.

2) Connect the horn connector to the driver airbag.

Legend

  1. Airbag connector
  2. Horn connector

3) Install the driver airbag to the steering wheel.

Note

  • Align each stud of the driver airbag with the steering wheel hole.

4) Press the driver airbag pushing section and install the driver airbag to the steering wheel.

Caution

  • Do not allow the harness to get caught.

Note

  • Check the sound of each stud engaging with the steering wheel.

Legend

  1. Pushing section

2. SRS airbag setting

1. SRS reactivation

Warning

  • Never use SRS parts from other vehicles or models.
  • Make sure to check the part numbers and use the SRS components intended for the target vehicle.

1) Set the ignition switch to LOCK and remove the key.

Note

  • For models with the passive entry and start system, turn the power mode OFF.

2) Make sure that the connectors of the SRS components (SRS airbag, SRS control unit, seat belt with pretensioner, SRS coil, etc.) are fully connected.

3) Install the SRS fuse to the fuse relay box, and connect the battery cable to the negative terminal of the battery.

4) Turn ON the ignition switch and verify that the SRS airbag warning light turns OFF after illuminating for 6 seconds.

Caution

  • If the SRS airbag warning light does not operate properly, perform Diagnostic system check - SRS controls.

5) Referring to the following, perform the setting of the front door power window switch with AUTO UP/AUTO DOWN function.

Refer to "9.Body, Cab, Accessories 9T.Glass, Windows, Mirrors front door power window switch setting".

Copyright Mazda Motor Corporation. All rights reserved.