Remote control mirror switch removal

1. Preliminary and post procedures

1. Preliminary procedures

1) Open the engine hood.

2) Disconnect the battery cable from the battery negative terminal.

Caution

  • After turning OFF the ignition switch (power mode for models with passive entry and start system), do not disconnect the battery cable within 3 minutes.
  • If the battery cable is disconnected within 3 minutes, the vehicle electronic control system may malfunction.
  • If the battery cable is disconnected, perform the setting of the front door power window switch with AUTO UP/AUTO DOWN function after connecting the battery negative terminal.

2. Front door power window switch removal

1) Remove the armrest from the front door trim pad.

Note

  • The armrest for Australia cannot be disconnected completely from the front door trim pad.

For Australia

Legend

  1. Armrest

Except for Australia

Legend

  1. Armrest

2) Remove the front door power window switch from the front door trim pad.

For Australia

Legend

  1. Front door power window switch
  2. Clip

Except for Australia

Legend

  1. Front door power window switch
  2. Clip

3) Disconnect the connector from the front door power window switch.

3. Remote control mirror switch removal

1) Remove the remote control mirror switch from the bezel.

Copyright Mazda Motor Corporation. All rights reserved.