EGR gas temperature sensor 1 (exhaust manifold side) removal (4JJ3 with DPD)

1. Preliminary and post procedures

1. Preliminary procedures

1) Open the engine hood.

2) Disconnect the battery cable from the battery negative terminal.

Caution

  • After turning OFF the ignition switch (power mode for models with passive entry and start system), do not disconnect the battery cable within 3 minutes.
  • If the battery cable is disconnected within 3 minutes, the vehicle electronic control system may malfunction.
  • If the battery cable is disconnected, perform the setting of the front door power window switch with AUTO UP/AUTO DOWN function after connecting the battery negative terminal.

2. Engine cover removal

1) Remove the engine cover from the engine.

Legend

  1. Engine cover

3. Intake hose removal

1) Remove the intake hose from the intercooler and turbocharger.

Legend

  1. Clamp
  2. Intake hose

4. Air cleaner removal

1) Disconnect the connector from the MAF and IAT sensor.

2) Remove the air cleaner from the vehicle.

Legend

  1. Air cleaner
  2. MAF and IAT sensor

5. EGR gas temperature sensor 1 (exhaust manifold side) removal

1) Disconnect the connector from EGR gas temperature sensor 1 (exhaust manifold side).

2) Remove the sensor connector from the water pipe.

3) Remove EGR gas temperature sensor 1 (exhaust manifold side) from the exhaust manifold.

Legend

  1. EGR gas temperature sensor 1 (Exhaust manifold side)
Copyright Mazda Motor Corporation. All rights reserved.