Charge air cooler temperature sensor 1 removal (4JJ3 with DPD)

1. Preliminary and post procedures

1. Preliminary procedures

1) Open the engine hood.

2) Disconnect the battery cable from the battery negative terminal.

Caution

  • After turning OFF the ignition switch (power mode for models with passive entry and start system), do not disconnect the battery cable within 3 minutes.
  • If the battery cable is disconnected within 3 minutes, the vehicle electronic control system may malfunction.
  • If the battery cable is disconnected, perform the setting of the front door power window switch with AUTO UP/AUTO DOWN function after connecting the battery negative terminal.

2. Front bumper removal

1) Remove the intake air duct from the air cleaner box and radiator core support.

Legend

  1. Intake air duct
  2. Clip

2) Remove the soft nose from the front bumper support.

3) Remove the front bumper support from vehicle.

Legend

  1. Clip
  2. Screw
  3. Soft nose
  4. Front bumper support

4) Remove the front bumper from the vehicle.

Legend

  1. Front bumper
  2. Clip

5) Disconnect the connector from the front bumper.

3. Charge air cooler temperature sensor 1 removal

1) Disconnect the connector from charge air cooler temperature sensor 1.

2) Remove charge air cooler temperature sensor 1 from the intercooler.

Legend

  1. Charge air cooler temperature sensor 1
  2. Intercooler
Copyright Mazda Motor Corporation. All rights reserved.