1. Preliminary and post procedures
1. Preliminary procedures
1) Open the engine hood.
2) Disconnect the battery cable from the battery negative terminal.
Caution
- After turning OFF the ignition switch (power mode for models with passive entry and start system), do not disconnect the battery cable within 3 minutes.
- If the battery cable is disconnected within 3 minutes, the vehicle electronic control system may malfunction.
- If the battery cable is disconnected, perform the setting of the front door power window switch with AUTO UP/AUTO DOWN function after connecting the battery negative terminal.
2. Engine cover removal
1) Remove the engine cover from the engine.
Legend
- Engine cover
3. Intake air duct removal
1) Disconnect the connector from charge air cooler temperature sensor 2.
2) Disconnect the air intake hose from the intercooler.
3) Remove the intake air duct from the intake throttle valve.
4. Swirl control solenoid valve removal
1) Disconnect the connector from the swirl control solenoid valve.
2) Disconnect the vacuum hose from swirl control solenoid valve.
3) Remove the swirl control solenoid valve and bracket as a set from the inlet manifold.
4) Remove swirl control solenoid valve from the bracket.