1. Disc brake pad inspection
1) Measure the thickness of the disc brake pad.
Standard: 10.0 mm { 0.394 in }
Limit: 1.5 mm { 0.059 in }
Note
- When the pad wear indicator makes a scratching sound or is worn to within 1.8 mm {0.071 in} of the shoe table, replace the pad.
Caution
- If replacing the disc brake pad, replace all 4 pads.
2. Brake rotor inspection
1. Visual inspection
1) Inspect for the following.
- Wear
- Bending
- Deterioration
- Corrosion
- Scratches
- Other malfunctions
2. Thickness measurement
1) Measure the thickness of the brake rotor.
| Specifications |
Standard value |
Limit |
| 2WD (Except high ride suspension specifications) |
30.0 mm { 1.181 in } |
28.0 mm { 1.102 in } |
| 2WD (High ride suspension specifications), 4WD |
30.0 mm { 1.181 in } |
28.0 mm { 1.102 in } |
3. Parallelism measurement
1) Measure the degree of parallelization of the brake rotor.
Note
- Measure at a position located 10 mm {0.04 in} inward of the brake rotor outer edge within 0.023 mm {0.0009 in} of the contact surface.
- Measure at 8 or more locations in the circumferential direction.
Limit: 0.023 mm { 0.00091 in }
3. Brake rotor vehicle inspection
1. Runout measurement
Correctly adjust the front hub preload before measuring.
1) Measure the runout using a dial gauge.
Note
- Measure at a position of 20 mm {0.79 in} from the brake rotor outer edge of the surface that makes contact with the disc brake pad.
Limit: 0.050 mm { 0.00197 in }