1. Pre-check and visual inspection
1) Inspect the battery voltage.
- If there is a malfunction in the battery voltage, charge or replace the battery.
2) Inspect the fuses.
- If an abnormal condition such as a blowout is found, inspect or repair the cause before replacing the fuses.
3) Inspect the ground point.
- If there is a failure with the ground point, repair and clean it.
4) Inspect the harnesses and connectors.
- Inspect for poor connections at the connectors, worn or bent harnesses, and for shorts to other circuits in the wires inside the harness, and repair as necessary.
5) Check for any interference from aftermarket electronic components.
- Turn OFF or remove any aftermarket electronic components such as two-way radios or lights to ensure that there is no influence on inspections or operations.
2. Components inspection
1) Inspect the blower resistor.
- Inspect the continuity and resistance using a DMM, and replace the blower resistor if a malfunction is found.
2) Inspect the fan switch.
- Inspect for continuity using a DMM, and replace the fan switch if a malfunction is found.
3. Inspection of circuit
1) Inspect the following circuits for abnormal conditions. If an abnormal condition is found, repair or replace.
Each terminal No. indicates the connector terminal at the chassis harness side.
- Between the blower motor No. 1 terminal and the fan switch No. 4 terminal