1. Engine harness vehicle inspection
1) Disconnect the engine harness from the TCM.
2) Measure the continuity between the terminals using a DMM.
Note
- Check that continuity is as specified in the table.
Caution
- Do not damage the terminals.
| Shift position |
P - IG |
R - IG |
N - IG |
D - IG |
| P range |
Continuity |
No |
No |
No |
| R range |
No |
Continuity |
No |
No |
| N range |
No |
No |
Continuity |
No |
| D range |
No |
No |
No |
Continuity |
Legend
- P
- R
- N
- D
- IG
2. Inhibitor switch vehicle inspection
1) Disconnect the harness from the connector.
2) Check for continuity between each connector terminal combinations listed in the table using a DMM.
Note
- Check that continuity is as specified in the table.
Caution
- Do not damage the terminals.
3. Automatic transmission control cable vehicle inspection
1) Inspect that the shift lever can be shifted smoothly and accurately when shifting the shift lever from N to another range.
2) Inspect that indicating light can be turned on correctly.
Caution
- If a problem is found, adjust the shift cable again so that there is no looseness in the cable.
- P0707 and P0708 may be set by improper automatic transmission control cable adjustments.