1. Component views
Cylinder head cover
Part name
- Oil filler cap
- Oil filler cap gasket
- Oil seal
- Nut
- Cylinder head cover
- Gasket
- O-ring
- Gasket
- Gasket
- Bolt
Tightening torque
4: 10.0 N・m { 1.0 kgf・m / 89 lb・in }
10: 10.0 N・m { 1.0 kgf・m / 89 lb・in }
2. Cylinder head cover installation
1) Install the oil seal to the cylinder head cover.
2) Install the gasket to the camshaft carrier.
Note
- Face the protruding section of the gasket toward the camshaft carrier side, and install.
Caution
- Do not reuse the gasket.
Legend
- Gasket
- Camshaft carrier
3) Apply engine oil to the cylinder head cover O-ring.
Caution
- Do not reuse the O-ring.
Legend
- O-ring
4) Referring to the diagram, apply ThreeBond 1207B to the cylinder head mating surface.
Caution
- Install the cylinder head cover within 5 minutes of applying liquid gasket.
- Remove any dirt or dust from the oil seal section on the injector connector side.
Standard value
b: 4.0 to 5.0 mm { 0.157 to 0.197 in } Bead width
c: 2.0 to 3.0 mm { 0.079 to 0.118 in } Bead height
Dimensions
a: 5.0 mm { 0.197 in }
5) Temporarily tighten the cylinder head cover to the cylinder head in the order shown in the diagram.
Caution
- Do not reuse the gasket.
6) Final tighten the cylinder head cover to the cylinder head in the order shown in the diagram.
Tightening torque: 10.0 N・m { 1.0 kgf・m / 89 lb・in }
7) Connect the harness clip to the cylinder head cover.
8) Connect the blow-by hose to the cylinder head cover.