1. Component views
Power seat
Part name
- Headrest holder
- Front seat headrest
- Front seat back cover
- Front seat back pad
- Front seat back frame
- Bolt
- Side cover
- Bolt
- Front buckle side seat belt
- Bolt
- Front seat cushion frame
- Reclining cover
- Switch knob
- Front seat cushion pad
- Front seat cushion cover
Tightening torque
6: 46 N・m { 4.7 kgf・m / 34 lb・ft }
8: 40 N・m { 4.1 kgf・m / 30 lb・ft }
10: 46 N・m { 4.7 kgf・m / 34 lb・ft }
Manual control seat (With height control)
Part name
- Headrest holder
- Front seat headrest
- Front seat back cover
- Front seat back pad
- Front seat back frame
- Bolt
- Bolt
- Front buckle side seat belt
- Side cover
- Nut
- Front seat cushion frame
- Bolt
- Seat slide adjuster
- Reclining cover
- Height adjustment lever
- Reclining lever
- Front seat cushion pad
- Front seat cushion cover
Tightening torque
6: 46 N・m { 4.7 kgf・m / 34 lb・ft }
7: 40 N・m { 4.1 kgf・m / 30 lb・ft }
10: 21 N・m { 2.1 kgf・m / 15 lb・ft }
12: 46 N・m { 4.7 kgf・m / 34 lb・ft }
Manual control seat (Without height control, integrated headrest type)
Part name
- Front seat back cover
- Front seat back pad
- Front seat back frame
- Bolt
- Bolt
- Front buckle side seat belt
- Side cover
- Bolt
- Seat slide adjuster
- Nut
- Front seat cushion frame
- Reclining cover
- Reclining lever
- Front seat cushion pad
- Front seat cushion cover
Tightening torque
4: 46 N・m { 4.7 kgf・m / 34 lb・ft }
5: 40 N・m { 4.1 kgf・m / 30 lb・ft }
8: 46 N・m { 4.7 kgf・m / 34 lb・ft }
10: 21 N・m { 2.1 kgf・m / 15 lb・ft }
2. Driver seat installation
1) Connect the connector to the driver seat.
2) Install the driver seat to the floor.
Tightening torque: 46 N・m { 4.7 kgf・m / 34 lb・ft }
3. SRS airbag setting
1. SRS reactivation
Warning
- Never use SRS parts from other vehicles or models.
- Make sure to check the part numbers and use the SRS components intended for the target vehicle.
1) Set the ignition switch to LOCK and remove the key.
Note
- For models with the passive entry and start system, turn the power mode OFF.
2) Make sure that the connectors of the SRS components (SRS airbag, SRS control unit, seat belt with pretensioner, SRS coil, etc.) are fully connected.
3) Install the SRS fuse to the fuse relay box, and connect the battery cable to the negative terminal of the battery.
4) Turn ON the ignition switch and verify that the SRS airbag warning light turns OFF after illuminating for 6 seconds.
Caution
- If the SRS airbag warning light does not operate properly, perform Diagnostic system check - SRS controls.
5) Referring to the following, perform the setting of the front door power window switch with AUTO UP/AUTO DOWN function.
Refer to "9.Body, Cab, Accessories 9T.Glass, Windows, Mirrors front door power window switch setting".